2.2.3.2. HA Configuration Routing

Set up a static route for each device.
For HA configurations, routing is set in [Workflow].
Click [WORKFLOWS] -> [Workflows] -> [Cluster Route Management].

Note

In the case of HA configuration, you can check the contents set in [Workflow] in [Routing] of [Device].

Cluster Route Management

2.2.3.2.1. Routing Default Value

At the default setting, any routing for the user network is not made.
The default gateway is not set either, so set it according to your network environment.


2.2.3.2.2. Routing : Setting Items

The following items are necessary for the routing settings.

Items

Values

Descriptions

ID

(Auto-Assign)

This ID is automatically assigned.

Destination IP Address

xxx.xxx.xxx.xxx

Input a Destination IP Address with decimal notation.

Mask xxx.xxx.xxx.xxx

Input the Destination Subnet mask with decimal notation.

Gateway

xxx.xxx.xxx.xxx

Input the Routing Gateway IP Address with decimal notation.

Interface

Port [ 4 - 10 ]

You need to select a port to which this Routing will be set up.

Comment

(Half-width alphabetic characters & half-width numbers)

Fill in your comment if you like.
Fill in your comment by using less than 225 letters. You can NOT utilize any two-bytes characters, such as Japanese.

Note

Default Gateway

  • If you want to set it as the default gateway, enter Destination IP 0.0.0.0, Mask 0.0.0.0 and specify the Gateway address and interface.



2.2.3.2.3. Prohibited IP address

The IP addresses below are not available for Interface, Routing, Address Objects, Destination NAT and Source NAT.
If these IP addresses are used, the operation may cause some error.
  • 100.65.0.0/16
  • 100.66.0.0/15
  • 100.68.0.0/14
  • 100.72.0.0/14
  • 100.76.0.0/15
  • 100.78.0.0/16
  • 100.80.0.0/13
  • 100.88.0.0/15
  • 100.91.0.0/16
  • 100.92.0.0/14
  • 100.126.0.0/15


2.2.3.2.4. Creating Additional Routing

  1. Click [Manage Routes] of [Cluster Route Management] displayed in [Workflow].
    Cluster Route Management

  1. Click [ Add ].
    Manage Routes

  1. Enter the setting value, and click [ Save ].
    For the details of setting items, please refer to Routing : Setting Items.
    parameters

  1. When the setting is ready, click [ Run Now ] to start applying.
    For the details of applying methods, please refer to Applying the settings.
    parameters


2.2.3.2.5. Routing Modification

  1. Click [Manage Routes] of [Cluster Route Management] displayed in [Workflow] from [Services].
    Cluster Route Management

  1. Select the target lines to be modified, and click the relevant button for operation.
    Manage Routes

    Descriptions of each button's function at the [ Manage Routes ]

    Buttons

    Descriptions

    Edit

    The user can modify the routing setting value that has already entered.

    Remove

    The user can delete the selected routing setting.


  1. When the setting is ready, click [ Run Now ] to start applying.
    For the details of applying methods, please refer to Applying the settings.
    parameters