Home >Documents >Security Tutorial v3.1.1 > 2. Operation > 2.2. Managed Firewall / Managed UTM Version2 > 2.2.3. Routing Settings >2.2.3.1. Single Configuration Routing

2.2.3.1. Single Configuration Routing

Set up a static route for each device.

For Single Configuration, the static route is specify at the [ Device Management ].

2.2.3.1.1. Default Value : Routing

At the default setting, any routing for the user network is not made.

By default, any gateway have not been set up. You need to set up a default gateway depending on your own environment.

2.2.3.1.2. Routing : Setting Items

The following items are necessary for the routing settings.

Items	Values	Descriptions
ID	(Auto-Assign)	This ID is automatically assigned.
Destination IP Address	xxx.xxx.xxx.xxx	Input a Destination IP Address with decimal notation.
Subnet Mask	xxx.xxx.xxx.xxx	Input the Destination Subnet mask with decimal notation.
Gateway	xxx.xxx.xxx.xxx	Input the Routing Gateway IP Address with decimal notation.
Interface	Port [ 4 - 10 ]	You need to select a port to which this Routing will be set up.
Comment	（Half-width alphabetic characters & half-width numbers)	Fill in your comment if you like. Fill in your comment by using less than 225 letters. You can NOT utilize any two-bytes characters, such as Japanese.

Note

Default Gateway

If you would like to set up a new default gateway, you need to firstly input {Destination IP 0.0.0.0] & [Subnet Mask 0.0.0.0] to specify a Gatewaty address and an Interface.

2.2.3.1.3. Prohibited IP address

The IP addresses below are not available for Interface, Routing, Address Objects, Destination NAT and Source NAT.

If these IP addresses are used, the operation may cause some error.

• 100.65.0.0/16
• 100.66.0.0/15
• 100.68.0.0/14
• 100.72.0.0/14
• 100.76.0.0/15
• 100.78.0.0/16
• 100.80.0.0/13
• 100.88.0.0/15
• 100.91.0.0/16
• 100.92.0.0/14
• 100.126.0.0/15

2.2.3.1.4. Adding Routing

1. Click the Routing from the left-side Object screen.

   Networking ‣ Routing

   Click [ Add ] at Routing of the right-side screen.

   

2. Click [ Save ] after you input the setting value.

   Routing : Setting Items : Setting Items to the setting value.

   

3. Apply configuration to the device by clicking [Apply configuration].

   

2.2.3.1.5. Routing Change (Edit/Duplicate/Remove)

1. Click the Routing from the left-side Object screen.

   Networking ‣ Routing

   Select the target changed line at Routing screen of the right-side. Click an operation button you need.

   

   
   

   Following describes respective buttons of Routing .

   Buttons	Descriptions
   Edit	Modify the value of Routing that has already been set.
   Duplicate	After duplicating the existing Routing , the object setting screen will open with the same value. This is useful for you to define another Routing with the same value.
   Remove	Delete the selected Routing .

   
   

   When you deleting one , the confirmation message will display. Please click [OK] to finally execute its deletion.

   

2. Apply configuration to the device by clicking [Apply configuration].

   

---

2.2.3. Routing Settings

2.2.3.2. HA Configuration Routing