Setting Items : Service ObjectΒΆ

Following are setting items of a Service Object.

Items

Values

Descriptions

Service Name

(Half-width alphabetical characters and half-width numbers)

Input the name of a Service Object.
You can NOT utilize any two-byte characters, such as Japanese, and the following signs as below:
< > ( ) # ' " Space (blank)

Protocol Type

[ICMP], [IP], [UDP] or [TCP]

Select a service protocol.

Comment

(Half-width alphabetical characters and half-width numbers)

Fill in any comments, if desired.
Input your comments by using less than 225 letters. You can NOT use any two-byte characters, such as Japanese.

Following are the additional setting items when you setting up [ ICMP ] as [ Protocol Type ] .

Items

Values

Descriptions

Type

(Half-width numbers)

Input an ICMP Type, if you want to specify it.
You can define a protocol as [ Any ], if you would like to stay one blank (space).

Code

(Half-width numbers)

Input an ICMP code, if you would like to specify it.
You can define a protocol as [ Any ], if you would like to stay one blank (space).

Following are additional setting items when you set up a Protocol Type as [ IP ].

Items

Values

Descriptions

Protocol Number

(Half-width numbers)

Input the IP Protocol Number, if you would like to specify it.
You can define a protocol as [ Any ], if you would like to stay one blank (space).

Following are the additional setting items of Security Service, if you set up either [ UDP ] or [ TCP ] as a Protocol Type.

Items

Values

Descriptions

Source Port

(Half-width numbers)

Input the destination port number, if you would like to specify it.
You can define a protocol as [ Any ], if you would like to stay one blank (space).

Destination Port

(Half-width numbers)

Input the destination port number, if you would like to specify one.
Input of the destination port number is absolutely needed. Therefore, to allow as Any, input "1-65535".