2.1.3.2. HA Configuration Routing

Set up a static route for each device.
For HA configuration, routing is set at [ Network Management ].
Click the [ Cluster Route Management ].

Note

For HA Configuration, the user can see the setting details, which was set at the [ Network Management ], at [ Routing ] in the [ Device Management ].

Cluster Route Management

2.1.3.2.1. Routing default value

In default setting, any route for the user network is not set.
By default, any gateway have not been set up. You need to set up a default gateway depending on your own environment.


2.1.3.2.2. Routing : Setting Items

The following items are necessary for the routing settings.

Items

Values

Description

ID

(Auto-Assign)

This ID is automatically assigned.

Destination IP Address

xxx.xxx.xxx.xxx

Input a Destination IP Address with decimal notation.

Mask xxx.xxx.xxx.xxx

Input the Destination Subnet mask with decimal notation.

Gateway

xxx.xxx.xxx.xxx

Input the Routing Gateway IP Address with decimal notation.

Interface

[ Port 4- Port 10 ]

You need to select a port to which this Routing will be set up.

Comment

(Half-width alphabetic characters & half-width numbers)

Fill in your comment if you like.
Fill in your comment by using less than 225 letters. You can NOT utilize any two-bytes characters, such as Japanese.

Note

Default Gateway

  • If you would like to set up a new default gateway, you need to firstly input {Destination IP 0.0.0.0] & [ Mask 0.0.0.0] to specify the Gatewaty address and an Interface.



2.1.3.2.3. Unauthorized IP addresses

The following IP addresses are not available for Interface, Routing, Address objects, Destination NAT and Source NAT.
When using these IP addresses, the operation may cause an error.
  • 100.65.0.0/16
  • 100.66.0.0/15
  • 100.68.0.0/14
  • 100.72.0.0/14
  • 100.76.0.0/15
  • 100.78.0.0/16
  • 100.80.0.0/13
  • 100.88.0.0/15
  • 100.91.0.0/16
  • 100.92.0.0/14
  • 100.126.0.0/15


2.1.3.2.4. Additional routing creation

  1. Click [ Manage Routes ] from [ Cluster Route Management ] shown in [ Network Management ].
    Cluster Route Management

  1. Click the [ Add ] button.
    Manage Routes

  1. Enter the setting value, and click [ Save ].
    For details of setting items, please refer to Routing : Setting Items.
    parameters

  1. When the setting is ready, click [ Run Now ] to start applying.
    For details of applying methods, please refer to Applying the settings.
    parameters


2.1.3.2.5. Routing modification

  1. Click [ Manage Routes ] from [ Cluster Route Management ] shown in [ Network Management ].
    Cluster Route Management

  1. Select the target lines to be modified, and click the relevant button for operation.
    Manage Routes

    Descriptions of each button's function at [ Manage Routes ].

    Buttons

    Description

    Edit

    Change the routing setting value that has already entered.

    Remove

    Delete the routing setting selected.


  1. When the setting is ready, click [ Run Now ] to start applying.
    For details of applying methods, please refer to Applying the settings.
    parameters