2.1.3.1. Single Configuration Routing

Set up a static route for each device.
For Single Configuration, the static route is specify at the [ Device Management ].

2.1.3.1.1. Default Value : Routing

In default setting, any route for the user network is not set.
By default, any gateway have not been set up. You need to set up a default gateway depending on your own environment.

2.1.3.1.2. Routing : Setting Items

The following items are necessary for the routing settings.

Items

Values

Description

ID

(Auto-Assign)

This ID is automatically assigned.

Destination IP Address

xxx.xxx.xxx.xxx

Input a Destination IP Address with decimal notation.

Subnet Mask

xxx.xxx.xxx.xxx

Input the Destination Subnet mask with decimal notation.

Gateway

xxx.xxx.xxx.xxx

Input the Routing Gateway IP Address with decimal notation.

Interface

[ Port 4- Port 10 ]

You need to select a port to which this Routing will be set up.

Comment

(Half-width alphabetic characters & half-width numbers)

Fill in your comment if you like.
Fill in your comment by using less than 225 letters. You can NOT utilize any two-bytes characters, such as Japanese.

Note

Default Gateway

If you would like to set up a new default gateway, you need to firstly input {Destination IP 0.0.0.0] & [Subnet Mask 0.0.0.0] to specify a Gatewaty address and an Interface.

Default Gateway

2.1.3.1.3. Unauthorized IP addresses

The following IP addresses are not available for Interface, Routing, Address objects, Destination NAT and Source NAT.
When using these IP addresses, the operation may cause an error.
  • 100.65.0.0/16
  • 100.66.0.0/15
  • 100.68.0.0/14
  • 100.72.0.0/14
  • 100.76.0.0/15
  • 100.78.0.0/16
  • 100.80.0.0/13
  • 100.88.0.0/15
  • 100.91.0.0/16
  • 100.92.0.0/14
  • 100.126.0.0/15


2.1.3.1.4. Routing Add

  1. Click the Routing from the left-side Object screen.
    Object ‣ Networking ‣ Routing

    Click [ Add ] at Routing of the right-side screen.

    Click Add


  1. Click [ Save ] after you input the setting value.
    Routing : Setting Items : Setting Items to the setting value.

    Save Object


  1. Apply configuration to the device by clicking [Save].

    Save Config



2.1.3.1.5. Routing Change(Update/Copy/Delete)

  1. Click the Routing from the left-side Object screen.
    Object ‣ Networking ‣ Routing

    Select the target changed line at Routing screen of the right-side. Click an operation button you need.

    Click Change


    Following describes respective buttons of Routing .

    Buttons

    Description

    Edit

    Modify the value of Routing that has already been set.

    Duplicate

    After duplicating the existing Routing , the object setting screen will open with the same value.
    This is useful for you to define another Routing with the same value.

    Remove

    Delete the selected Routing .


    When you deleting one , the confirmation message will display. Please click [OK] to finally execute its deletion.

    Confirm Delete Object


  1. Apply configuration to the device by clicking [Save].

    Save Config