7.2.1. Creating a New File Storage

For configuring new Block Storage, it is necessary to complete these 2 tasks: 1. [ Create Virtual Storage ] ; 2. [ Add Volume ]. Creating a Virtual Storage

Click [ Create Virtual Storage ] on the below screen.


Specify the following parameters when your creating [ Virtual Storage ].



Name of a Virtual Storage being Created.

Volume Type

First, choose “pre_nfs_na”

Logical Network

Select a destination Logical Network being connected to your Virtual Storage from the pull-down menu. You must create the destination Logical Network in advance.


Select a destination Subnet, whicht the Virtual Server connects to. The selectable Subnet is one which exists in the selected Logical Network above.

IP Address Pool

You can destinate a specific Range of the IP Address enabling utilization as a Virtual Storage.

Adding a New Routes (Host Rout)

You can input the additional Routing information being configured for a Virtual Storage.

Once you input the Information, click [ Create Virtual Storage ] and verify that the relevant Virtual Storage has been created successfully.


Only storage plane is the accessible Logical Network upon a File Storage.

Creating a File Storage Volume.

Once the Virtual Storage has been created, proceed to a new Volume creation. Click [ Add New Volume ] in a Virtual Storage, where you would like to create a new Volume.


You need to configure the following items required to input for creating a new Volume.


Volume Name

This is a name of the Volume being created. NOTE: You need to create a unique name within your Tenant.


You can input the description about the Virtual Volume.

Specify the variables on the Volume size you will create, the Throughput, the Zone and the Group upon the “Details” tab at the “Create Volume” page. You can choose respective items above from the pull-down menu.


Once you have registered the above respective information, click [ Create Volume ].