11. Setting Communication RoutesΒΆ

This chapter describes the steps to set up the communication routes for vFirewall and an Integrated Network Appliance (INA). Listed below are the contents described in this chapter.

  • In the case of vFirewall
    • Setting an IP address object
    • Setting an IP address group
    • Setting a service object
    • Adding a service group
    • Setting NAT/NAPT
    • Setting a static routing
    • Setting a filtering
    • Changing the resource level of vFirewall

  • In the case of an integrated network appliance (INA)
    • Setting a firewall
    • Setting NAT
    • Setting a static routing

Set up the communications routes depending on the environment in use.

  • The Internet gateway, the VPN gateway, the vLoad Balancer, and the server segment have the alias IP’s set for executing communications. When you set up a filter rule, NAT rule, routing, or the like, if you use an IP address of the above-mentioned equipment, use the alias IP.