2.4.5. Agent for Linux

If the backup target server is Linux server, install the server according to the following procedure.
* This section describes the installation procedure for GUI.
* In case of using the centralized management type, SSH needs to be permitted at root.
① Grant the execution permission to the installation module.
$ chmod 755 AcronisBackup_12.5_64-bit.x86_64

② Confirm that the installation module is executable.
$ ls -l
-rwxr-xr-x 1 root root 1097707464 Nov  8 16:20 2017 AcronisBackup_12.5_64-bit.x86_64

③ Run the installation module.
$ ./AcronisBackup_12.5_64-bit.x86_64

④ When the following screen appears, select “Next” and then press the [Enter] key.
../../../_images/115.png

⑤ When the license agreement screen appears, select “Accept” and then press the [Enter] key.
../../../_images/215.png

⑥ As for the local type configuration, select “Next” and then press the [Enter] key while all components are selected. As for Acronis12.5, introduction of the management server is required.
As for the centralized management type, proceed to the step ⑨.
* Be sure to install all components.
../../../_images/37.png

⑦ Select the port used for the management server. In this case, select “Next” and then press the [Enter] key while keeping the default setting.
../../../_images/45.png

⑧ Select the port used for communications between components. In this case, select “Next” and then press the [Enter] key while keeping the default setting.
Proceed to the step ⑪.
../../../_images/55.png

⑨ As for the centralized management type, the management server has already been implemented in another server so that remove the check mark from the “Acronis Backup Management Server” and “Acronis Monitoring Service” check boxes and select “Next” and then press the [Enter] key.
* “Acronis Backup Agent for Linux” and “Acronis Bootable Media Builder” are required.
../../../_images/63.png

⑩ Enter IP address, users who connect to the management server and password on the following screen, and then select “Next” and then press the [Enter] key.
../../../_images/73.png

⑪ Please wait until installation completes.
../../../_images/82.png

⑫ When the following screen appears, installation is completed. In this case, select “Exit” and then press the [Enter] key.
../../../_images/92.png